Disabling output controls in Synergis™ Softwire 11.0 - Synergis™ Softwire 11.0

Synergis™ Appliance Configuration Guide 11.0

Applies to
Synergis™ Softwire 11.0
Last updated
2021-08-24
Content type
Guides > Administrator guides
Language
English (United States)
Product line
Synergis > Synergis™ Softwire
Version
11.0

To prevent doors from being unlocked through Synergis™ Appliance Portal, you can disable the control of output states.

What you should know

  • If you disable output controls, you can view the output states, but can no longer change them on the I/O diagnostics page.
  • You can only re-enable output controls by running a DIP switch command on the Synergis™ Cloud Link appliance.

Procedure

  1. Log on to the Synergis™ unit.
  2. Click Configuration > Unit-wide parameters.
  3. In the Output controls section, click Disable output controls.
    The Output controls dialog box opens and prompts you to proceed.
  4. Click OK.

Results

The Disable output controls button disappears, and the following message is displayed: Output controls have been disabled.