Configuring the Synergis™ unit - Synergis™ Softwire 11.2

Synergis™ Appliance Configuration Guide 11.2

Applies to
Synergis™ Softwire 11.2
Last updated
2022-01-11
Content type
Guides > Administrator guides
Language
English
Product
Synergis™ Softwire
Version
11.2

You can configure the Synergis™ unit after the pre-configuration steps are completed.

Procedure

  1. All Synergis™ units come with a factory-assigned hostname. If your network does not support DHCP, you must assign the appliance a new IP address.
  2. (Optional) Change the default X.509 certificate of the unit.
  3. Upgrade the Synergis™ appliance firmware to the latest version.
  4. Physically attach the interface modules to the Synergis™ unit.
  5. Establish communication between the Synergis™ unit and its attached interface modules through the Synergis™ Appliance Portal.
  6. Test your hardware connections and configuration and make adjustments if necessary.
  7. Configure the access control behavior of the Synergis™ unit.
  8. Add the Synergis™ unit to an Access Manager so it becomes part of your Security Center system.