Disabling output controls in Synergis™ Softwire 11.2 - Synergis™ Softwire 11.2

Synergis™ Appliance Configuration Guide 11.2

Applies to
Synergis™ Softwire 11.2
Last updated
Content type
Guides > Administrator guides
English (United States)
Synergis™ Softwire

To prevent doors from being unlocked through the Synergis™ Appliance Portal, you can disable the control of output states.

What you should know

  • If you disable output controls, you can view the output states, but can no longer change them on the I/O diagnostics page.
  • You can only re-enable output controls by running a DIP switch command on the Synergis™ Cloud Link appliance.


  1. Log on to the Synergis™ unit.
  2. Click Configuration > Unit-wide parameters.
  3. In the Output controls section, click Disable output controls.
    The Output controls dialog box opens and prompts you to proceed.
  4. Click OK.


The Disable output controls button disappears, and the following message is displayed: Output controls have been disabled.