Configuring the network properties of the Synergis™ unit - Synergis™ Softwire 11.3.4

To make sure that the Synergis™ unit can be reached on your Security Center system’s network, you must configure the unit's network properties.

1. Log on to the Synergis™ unit.
2. Click Configuration > Network.
3. In the Access Manager settings section, change the Discovery port if necessary.
4. In the Network settings section, select the LAN1 or LAN2 as the network interface used to connect the Synergis™ unit to its Access Manager, and then configure the Synergis™ unit’s IP address and network properties.
   IMPORTANT: If the Synergis™ unit is not on the same network segment as the Access Manager, then the unit's IP address must be set to Static IP or DHCP with Static IP allocation.
   
5. Click Save.