Configuring the Synergis™ unit - Synergis™ Softwire 11.3

Synergis™ Appliance Configuration Guide 11.3

Applies to
Synergis™ Softwire 11.3
Last updated
2022-09-27
Content type
Guides > Administrator guides
Language
English
Product
Synergis™ Softwire
Version
11.3

You can configure the Synergis™ unit after the pre-configuration steps are completed.

Procedure

  1. All Synergis™ Cloud Link units come with a factory-assigned hostname. If your network does not support DHCP, you must assign the unit a new IP address.
  2. (Optional) Change the default X.509 certificate of the unit.
  3. Upgrade Synergis™ Softwire to the latest version.
  4. Apply the latest cumulative security rollup to the Synergis™ Cloud Link unit.
  5. Physically attach the interface modules to the Synergis™ unit.
  6. Establish communication between the unit and its attached interface modules through the Synergis™ Appliance Portal.
  7. Test your hardware connections and configuration and make adjustments if necessary.
  8. Configure the access control behavior of the Synergis™ unit.
  9. Add the Synergis™ unit to an Access Manager so it becomes part of your Security Center system.