Disconnecting MR panels from a Mercury controller - Synergis™ Softwire 11.3

Synergis™ Appliance Configuration Guide 11.3
Applies to
Synergis™ Softwire 11.3
Last updated
2022-09-27
Content type
Guides > Administrator guides
Language
English
Product
Synergis™ Softwire
Version
11.3

To disconnect a Mercury MR panel from a Mercury controller that is enrolled in Security Center, you can delete the panel from the controller in Config Tool.

What you should know

Mercury MR panels must be offline in Security Center before you can delete them.

Procedure

  1. From the Config Tool home page, open the Access control task.
  2. Click Roles and units, select your Synergis™ unit, and click the Peripherals tab.
  3. If the MR panel is controlling doors or zones, then disconnect them.
  4. Disconnect the panel:
    • Disconnect power from the panel and wait until it goes offline in Config Tool.
    • Click the Peripherals tab, select the panel, click Edit, then change the Address of the panel so it disconnects from the controller and goes offline in Config Tool.
  5. Click the Peripherals tab, select the panel, click Delete, and then click Apply.