Adding BEST Wi-Q locks and wireless access controllers to the gateway - Synergis Softwire 11.4.0

You must add BEST Wi-Q locks and wireless access controllers to the gateway in Config Tool.

1. From the Config Tool home page, open the Access control task.
2. Click Roles and units, and then click the Synergis™ unit.
3. Click the Peripherals tab, and then double-click the Mercury LP4502 controller.
4. In the dialog box that opens, double-click the BEST Wi-Q gateway in the Interfaces list.
5. In the dialog box that opens, click Add an item () under the Interfaces list.
   A dialog box opens with BEST Wi-Q Lock selected as the Model. This option is used for locks and wireless access controllers.
6. Enter the Door lock number for the lock or WAC, and then click OK.
   

   NOTE: The door lock number must match the ACR ID that was assigned to the lock or WAC on web page of the BEST Wi-Q gateway.

   
7. Click OK > OK.
8. Click Apply.

Results

The Mercury controller, BEST Wi-Q gateway, and locks are displayed on the Peripherals page.

On the web page of the BEST Wi-Q gateway, the status of the lock or WAC you added in Config Tool turns green.

After you finish

Assign the lock or WAC I/Os to doors in Config Tool. You can use the Card In, Rex Out door template to speed up configuration.

Example: The following image shows a typical configuration on a door's Hardware page.