Pairing Aperio-enabled locks with the AH40 IP hub - Synergis Softwire 11.4.0

Synergis™ Appliance Configuration Guide 11.4.0

Applies to
Synergis Softwire 11.4.0
Last updated
2023-03-28
Content type
Guides > Administrator guides
Language
English
Product
Synergis Softwire
Version
11.4

If you use Aperio-enabled locks with an AH40 hub, you must configure the hub using the Aperio Programming Application (APA) before you can enroll the locks on your Synergis™ unit.

Before you begin

Ensure that you have the following:
  • Aperio Online Programming Application Manual
  • Aperio Programming Application (APA)
  • USB dongle
  • TriBee Bootloader, which includes the USB dongle driver
  • Supported firmwares
  • Computer for running the APA
  • Card that is compatible with the reader

Procedure

  1. Power on the hub.
  2. Plug the USB dongle into your computer and install the following:
    • TriBee Bootloader (driver for the USB dongle)
    • Aperio Programming Application (APA)
  3. Use APA to configure the hub:
    1. Update the firmware on the hub and the locks.
      Best Practice: Upgrade the communication hub before upgrading the locks or sensors.
    2. Pair the hub with the readers.
      Selecting the AH40 IP hub in APA automatically pairs the hub with the readers.
      NOTE: Take note of the port number. You need it to enroll the hub in the Synergis™ Appliance Portal.
    3. Specify the IP address of the Synergis unit as the ACU address.
      Example: