MR51e is a single door PoE panel that must be controlled through a Mercury controller. For the MR51e panel to communicate with the controller, you must set the MR51e panel to use either the Public DHCP (recommended) or the Static IP addressing mode.
Before you begin
- If not already done, load the MR51e panels with the supported firmware version.
- Enroll the controller on your Synergis™ unit.
- If the MR51e panels are using the Static IP addressing mode, download the MSC MR51e Address Configuration Tool from the Mercury website.
What you should know
NOTE: Reader port 1 on the MR51e panel can support up to two OSDP
readers.