Readers connected to the MR62e downstream panel must be addressed and used in specific pairs to work.
The following table shows the required reader address configuration:
| Reader number (address) | Door setup | Mercury turnstiles and elevators |
|---|---|---|
| 0 | Door 1: Reader side IN | Yes |
| 1 | Door 2: Reader side IN | Yes |
| 2 | Door 1: Reader side OUT | No |
| 3 | Door 2: Reader side OUT | No |
NOTE: To use the MR62e to control only one Card In/Card Out door, use addresses 0 and
2.
To use the MR62e to control two Card In/REX Out doors, use addresses 0 and 1.