Configuring the Synergis unit - Synergis Softwire 11.4.3

Synergis™ Appliance Configuration Guide 11.4.3
Product
Synergis™ Softwire
Content type
Guides > Administrator guides
Version
11.4
Release
11.4.3
Language
English
Last updated
2024-04-16

You can configure the Synergis™ unit after the pre-configuration steps are completed.

Before you begin

Perform the pre-configuration steps.

Procedure

  1. All Synergis™ Cloud Link units come with a factory-assigned hostname. If your network does not support DHCP, you must assign the unit a new IP address.
  2. (Optional) Change the default X.509 certificate of the unit.
  3. Upgrade Synergis™ Softwire to the latest version.
  4. Apply the latest cumulative security rollup to the Synergis Cloud Link unit.
  5. Physically attach the interface modules to the Synergis unit.
  6. Establish communication between the unit and its attached interface modules through the Synergis™ Appliance Portal.
  7. Test your hardware connections and configuration and make adjustments if necessary.
  8. Configure the access control behavior of the Synergis unit.
  9. Add the Synergis unit to an Access Manager so it becomes part of your Security Center system.