Disabling output controls on the Synergis Cloud Link unit - Synergis Softwire 11.4.3

Synergis™ Appliance Configuration Guide 11.4.3

Product
Synergis™ Softwire
Content type
Guides > Administrator guides
Version
11.4
Release
11.4.3
Language
English
Last updated
2024-04-16

To prevent doors from being unlocked through the Synergis™ Appliance Portal, you can disable the control of output states.

What you should know

  • If you disable output controls, you can view the output states, but can no longer change them on the I/O diagnostics page.
  • You can only re-enable output controls by running a DIP switch command on the Synergis™ Cloud Link appliance.

Procedure

  1. Log on to the Synergis unit.
  2. Click Configuration > Unit-wide parameters.
  3. In the Output controls section, click Disable output controls.
    Disable output controls button in the Output controls section of the Unit-wide parameters page in the Synergis™ Appliance Portal.
    The Output controls dialog box opens and prompts you to proceed.
  4. Click OK.

Results

The Disable output controls button disappears, and the following message is displayed: Output controls have been disabled.
Output controls section of the Unit-wide parameters page in the Synergis™ Appliance Portal after output controls have been disabled.