Configuration overview for Assa Abloy IP locks - Synergis™ Cloud Link 2.0.4

Synergis™ Cloud Link Administrator Guide 2.0.4

Applies to
Synergis™ Cloud Link 2.0.4
Last updated
2022-09-15
Content type
Guides > Administrator guides
Language
English (United States)
Product
Synergis™ Cloud Link
Version
2.0

To configure Assa Abloy IP locks to work with a Synergis™ unit, you must first configure the locks with the Lock Configuration Tool (LCT), and then pair the locks to the Synergis™ unit using the Synergis™ Appliance Portal.

The following table summarizes the IP lock configuration process.
Phase Description See
1 Make sure that your IP lock firmware is up to date and supported by your version of Synergis™ Softwire.
2 Configure the IP lock using the LCT.
  • Configure the Host address of the IP lock to be the same as the IP address of the Synergis™ unit.
  • Configure the communication port of the IP lock that the Synergis™ unit uses as a listening port when discovering the locks (Default=2571).
  • If encryption is required, set the AES key in the lock profile. You need this key after you pair the IP lock with the Synergis™ unit.
  • Network & Lock Configuration Tool User Manual that came with your lock.
3 Establish communication between the Synergis™ unit and its connected IP locks in the Synergis™ Appliance Portal.