Enrolling Allegion Schlage AD locks and PIM modules on the Synergis™ unit - Synergis™ Cloud Link 2.0.4

Synergis™ Cloud Link Administrator Guide 2.0.4

Applies to
Synergis™ Cloud Link 2.0.4
Last updated
2022-09-15
Content type
Guides > Administrator guides
Language
English (United States)
Product
Synergis™ Cloud Link
Version
2.0

Because the Synergis™ unit does not communicate with Allegion Schlage AD locks or PIM400 modules directly, you must enroll these devices through a Mercury EP or LP (or Honeywell) controller, using Config Tool.

Before you begin

What you should know

Mercury controllers enrolled on a Synergis™ unit are not visible from the Synergis™ Appliance Portal Hardware page.

On the Synergis™ unit, each Mercury controller must by assigned a unique channel ID. All Mercury controllers have RS-485 buses to which the Schlage devices (AD-300 and PIM400) are connected. Each Schlage device connected to the same RS-485 bus must have a unique RS-485 address.

Procedure

  1. From the Config Tool home page, open the Access control task.
  2. Click Roles and units, and then click the Synergis™ unit.
  3. Click Peripherals, and then click Add an item ().
    Dialog box that opens in Config Tool when you add peripherals to a Synergis™ unit.
  4. Enter the following information:
    Model
    Model of the controller.
    IP address
    Static IP address assigned to the controller by your IT department.
    Port
    Communication port (default=3001). The port must match the value configured on the Mercury Device Manager web page.
    Channel
    Channel ID corresponding to this controller. The channel ID can be any value from 0 to 63, and must be unique within the Synergis™ unit. After it is assigned, it must not be changed.
  5. Add the Allegion Schlage devices that are connected to your EP or LP controller.
    1. Under the Interfaces list, click Add an item ().
    2. In the dialog box that opens, select the Model (AD-300 or PIM400), the Port, and the Address (0 - 31 ).
    3. (PIM400 only) In Low, enter the first door number linked to the PIM400, and in Count, enter the number of doors linked to the PIM400.
      All door numbers ranging from Low to Low+Count must correspond to an AD-400 wireless lock.
    4. Click OK.
    5. Repeat as necessary.
  6. (Optional) Click Advanced settings to change the advanced settings.
    The available settings depend on the selected controller model. You can typically change the baud rate of the available serial port, the custom supervised input values, and the power input event configuration.
    Advanced settings dialog box for a Mercury controller in Config Tool.
    NOTE: You can set up to four different custom presets on your Mercury controller's inputs. For users upgrading from earlier Security Center versions who have a custom value configured, that preset is listed as Custom 1 in the AD limit rows list.
  7. Click OK at the bottom of the dialog box.
  8. Click Apply.
    The Mercury controller with all its connected downstream panels and peripheral devices are listed on the Peripherals page.
    Peripherals page of a Mercury controller in Config Tool.
    Adding interface modules to the Synergis™ unit causes the unit to perform a software restart. During this process, the Synergis™ unit and all peripherals attached to it are displayed in red.