Enrolling Allegion Schlage AD locks and PIM modules on the Synergis unit - Synergis Cloud Link 2.1.1

Because the Synergis™ unit does not communicate with Allegion Schlage AD locks or PIM400 modules directly, you must enroll these devices through a Mercury EP or LP (or Honeywell) controller, using Config Tool.

1. From the Config Tool home page, open the Access control task.
2. Click Roles and units, and then click the Synergis unit.
3. Click Peripherals, and then click Add an item ().
   
4. Enter the following information:

   Model

   Model of the controller.

   IP address

   Static IP address assigned to the controller by your IT department.

   Port

   Communication port (default=3001). The port must match the value configured on the Mercury Device Manager web page.

   Channel

   Channel ID corresponding to this controller. The channel ID can be any value from 0 to 63, and must be unique within the Synergis unit. After it is assigned, it must not be changed.

5. Add the Allegion Schlage devices that are connected to your EP or LP controller.
   1. Under the Interfaces list, click Add an item ().
   2. In the dialog box that opens, select the Model (AD-300 or PIM400), the Port, and the Address (0 - 31 ).
   3. (PIM400 only) In Low, enter the first door number linked to the PIM400, and in Count, enter the number of doors linked to the PIM400.
      All door numbers ranging from Low to Low+Count must correspond to an AD-400 wireless lock.
   4. Click OK.
   5. Repeat as necessary.
6. (Optional) Click Advanced settings to change the advanced settings.
   The available settings depend on the selected controller model. You can typically change the baud rate of the available serial port, the custom supervised input values, and the power input event configuration.

   

   NOTE: You can set up to four different custom presets on your Mercury controller's inputs. For users upgrading from earlier Security Center versions who have a custom value configured, that preset is listed as Custom 1 in the AD limit rows list.
7. Click OK at the bottom of the dialog box.
8. Click Apply.
   The Mercury controller with all its connected downstream panels and peripheral devices are listed on the Peripherals page.

   

   Adding interface modules to the Synergis unit causes the unit to perform a software restart. During this process, the Synergis unit and all peripherals attached to it are displayed in red.