You can use the four inputs on the Synergis™ Cloud Link appliance to monitor external events in the access control system.
The monitoring inputs can be configured by software as supervised or unsupervised,
each requiring a specific resistor configuration.
NOTE: Synergis™ Cloud
Link inputs must not be used as REX (Request To
Exit) in UL294-compliant installations.
Monitoring input connector pinout
| Pin | Description |
|---|---|
| + | Input signal |
| - | Input return signal |
Resistor configuration
The supervision of Synergis™ Cloud Link monitoring inputs must be configured in Config Tool. For more information, see Configuring the monitoring inputs on the Synergis™ Cloud Link appliance.
Refer to the following electrical diagram for information on how to configure the resistors.
3-state supervision wiring
Normally closed:
Normally open:
4-state supervision wiring
Normally closed:
Normally open:
Unsupervised input wiring
Normally closed:
Normally open:
