Supported Synergis™ IX controller features in Synergis™ Softwire 10.10 - Australia and New Zealand only

Synergis™ IX Deployment Guide 5.8

Applies to
Australia and New Zealand only
Last updated
Content type
Guides > Deployment guides
English (United States)
Synergis™ IX

Synergis™ IX controllers support a wide range of access control features that depend on the version of Synergis™ Softwire you use.

Synergis™ Softwire 10.10 supports the following Synergis™ IX controller features.
The following is the legend for some common values found in the Supported column:
Feature is offered by the interface module and is supported by Synergis™ Softwire.
Feature is offered by the interface module but is not supported by Synergis™ Softwire.
Not applicable
Feature is not offered by the interface module.
Features Supported
General characteristics  
Category of interface module (SY-SIX-CTRL-DIN or SY-SIX-CTRL-DIN-1D) Intelligent controller
Communication protocol IP
Encrypted communication Yes (TLS 1.2)
Online operation (connected to the Synergis™ unit)  
Supervised mode No
Dependent mode No
Offline operation (no connection to the Synergis™ unit)  
Standalone mode Yes
Degraded mode Not applicable
Reader communication protocols  
Wiegand Yes
OSDP (Secure Channel) No
Clock and Data (Magnetic Stripe), also known as ABA format No
F2F Not applicable
Proprietary Yes
Maximum number of credentials (for autonomous decision making) 4 000
Maximum credential length (in bits)1 40
Maximum number of interface modules per Synergis™ unit RS-485 channel Not applicable
Recommended maximum number of interface modules per Synergis™ unit 16

1 All credentials stored on a given Synergis™ IX controller must be of the same bit length.