Enrolling the NXT module connected to the Synergis unit - Synergis Softwire 11.4

For the Synergis™ unit to communicate with the NXT interface module, you must enroll the module in the Synergis™ Appliance Portal.

1. Log on to the Synergis unit.
2. Configure a network adapter:
   NOTE: The following example uses LAN 2.
   1. Click Configuration > Network.
   2. In the Network settings section, click LAN 2.
   3. Configure the IP address and network properties of the LAN 2 connector, and then click Save.
3. Click Hardware.
4. Click Add ().
   
5. In the Add hardware dialog box, enter the following:

   Hardware type

   Select Keri.

   Channel

   Select the Ethernet adapter connecting your unit to the LAN where the NXT module is connected.

   IP address

   Enter the static IP address reserved by your IT department for the NXT module.

   Mac address

   Enter the MAC address of the NXT module printed on the label sticker.

   NOTE: When the NXT module is assigned an IP address, it cannot be changed unless the module is factory reset.
6. Click Save.
   The new NXT module appears in the Hardware configuration pane.
7. Select the newly added NXT module.
8. In the dialog box that opens, select Has EntraGuard.
9. (Optional) Select Make all decisions for the NXT module to make all access control decisions as if it’s operating in degraded mode (disconnected from the Synergis unit).
   
10. Click Save.
11. (Optional) To connect another NXT module to LAN 1 on the same unit, repeat steps 2 - 10.