Not all Security Center access control features are supported with the integration of Keri EntraGuard systems.
The Keri EntraGuard system integration supports the following Security Center access control features.
The following is the legend for some common
values found in the Supported column:
- Yes
- Feature is supported by this integration.
- Limited
- Part of the feature is not supported.
- No
- Feature is not supported by this integration.
- Online
- Feature is supported only when the interface module is connected to the Synergis unit.
- Not applicable
- Feature does not apply to this integration.
| Feature group | Security Center feature | Supported |
|---|---|---|
| Door behavior settings (overrides the Synergis unit-wide settings) | Maintenance mode (keep door unlocked and ignore all access events) | Yes |
| Standard grant time | Yes | |
| Extended grant time | No | |
| Entry time (Standard/Extended) 1 | No | |
| Request to exit (REX) options | ||
| Unlock on REX (On/Off) | Yes | |
| Time to ignore REX after granting access (in seconds) | Yes | |
| Ignore REX events while door is open (On/Off) | Yes | |
| Time to ignore REX after door closes (in seconds) | Yes | |
| Manual actions on doors in Security Desk 2 | Manually unlock doors | Yes |
| Reader shunting (activate/deactivate reader) | No | |
| Override unlock schedules | Not applicable | |
| Live event monitoring in Security Desk | Module running state (Online, Offline) | Yes |
| AC fail | No | |
| Battery fail (Low battery) | EntraGuard only | |
| Door open/closed | Yes | |
| Door locked/unlocked | Yes | |
| Door forced open | Yes | |
| Door held open for too long | Yes | |
| Door secured | Not applicable |
1 Security Center requires an entry sensor to accurately detect entry into an area. In the absence of the entry sensor, Security Center uses the door sensor, and the Entry detected event is generated when the door sensor is triggered. In the absence of both sensors, Security Center generates the Entry assumed event when access is granted.
2 The Synergis unit must be connected to the Access Manager.