Configuring the Aperio AH40 IP hub - Synergis™ Softwire 11.0

Synergis™ Softwire Integration Guide 11.0

series
Synergis™ Softwire 11.0
revised_modified
2020-11-27
category_custom
Guides
Guides > Integration guides
prodname_custom
Synergis > Synergis™ Softwire
vrm_version
11.0

If you use Aperio-enabled locks with an AH40 hub, you must configure the hub using the Aperio Programming Application (APA) before you can enroll the locks on your Synergis™ unit.

Before you begin

Ensure that you have the following:
  • Aperio Online Programming Application Manual
  • Aperio Programming Application (APA)
  • USB dongle
  • TriBee Bootloader. Includes the USB dongle driver
  • Supported firmwares.
  • Computer for running the APA
  • Card that is compatible with the reader

Procedure

  1. Power on the hub.
  2. Plug the USB dongle into your computer and install the following:
    • TriBee Bootloader (driver for the USB dongle)
    • Aperio Programming Application (APA)
  3. Use APA to configure the hub:
    1. Update the firmware on the hub and the locks.
      Best Practice: Upgrade the communication hub before upgrading the locks or sensors.
    2. Pair the hub with the readers.
      Selecting the AH40 IP hub in APA automatically pairs the hub with the readers.
      NOTE: Take note of the port number. You need it to enroll the hub in Synergis™ Appliance Portal.
    3. Specify the IP address of the Synergis™ unit as the ACU address.
      Example:
  4. Log on to the Synergis™ unit.
  5. Click Configuration > Hardware.
  6. At the top of the Hardware column, click Add ().
  7. In the Add hardware dialog box, select Aperio IP as the Hardware type, and enter the port number of the hub in the Port field. The default port is 9999.
  8. Click Save.
  9. Click Edit () on the Aperio IP interface.
    The configuration dialog box of the channel opens.
  10. In the configuration dialog box, select the Enroll check box for the hub you want to enroll.
    NOTE: If you have configured more than one AH40 hub on the same port, all connected hubs and their MAC addresses are listed.
  11. Click Save.
    The locks connected to the enrolled AH40 hub are listed in the hardware tree and turn green. This can take up to two minutes.