Reader connections on the Axis controller - Synergis™ Softwire 11.0

Synergis™ Softwire Integration Guide 11.0

series
Synergis™ Softwire 11.0
revised_modified
2020-11-27
category_custom
Guides
Guides > Integration guides
prodname_custom
Synergis > Synergis™ Softwire
vrm_version
11.0

Each Axis controller supports up to two readers, called Reader 1 and Reader 2 in Security Center Config Tool. The readers can use either Wiegand (default) or OSDP protocol. For OSDP, the reader must be wired to the first set of reader data A-/B+.

The following chart shows which set of connectors correspond to which reader on the Axis controller.
NOTE: This pin chart only shows up if the Axis controller is disconnected to the Synergis™ unit.