Supported OSDP readers in Synergis™ Softwire 11.0 - Synergis™ Softwire 11.0

Synergis™ Softwire Integration Guide 11.0

series
Synergis™ Softwire 11.0
revised_modified
2020-11-27
category_custom
Guides
Guides > Integration guides
prodname_custom
Synergis > Synergis™ Softwire
vrm_version
11.0

With Secure Open Supervised Device Protocol (OSDP), you can move away from Wiegand readers without making a large infrastructure investment, because only the readers need to be replaced.

The following OSDP readers were certified and are supported by Synergis™ Softwire 11.0. Certified readers were tested for use with random-key encrypted communication. Other OSDP-compliant readers are supported by design.
Manufacturer Model Certified firmware
Allegion
  • aptiQ/Schalge MT15-485 X14_14 reader
FW1212
Deister
  • PRD6
2.89
HID
  • HID Global iCLASS SE R10 (900, OSDP)
  • HID Global iCLASS SE R15 (910, OSDP)
  • HID Global iCLASS SE R40 (920, OSDP)
  • HID Global iCLASS SE RK40 (921, OSDP)
  • HID Global iCLASS SE Decor (R95A, OSDP)
00312-F, 00316-F
STid
  • ARC-A, OSDP version (ARC-W33-A/PH5-7OS/1)
  • ARC-B, OSDP version (ARC-W33-B/PH5-7OS/1)
  • ARC1, OSDP version (ARC1-W33-X/PH5-7OS/1)
  • ARCS-A/BT, OSDP version (ARCS-W33-A/BT1-7OS/y)
  • ARCS-B/BT, OSDP version (ARCS-W33-B/BT1-7OS/y)
v08

Supported Synergis™ appliances

OSDP readers connect directly to the RS-485 ports on a Synergis™ Cloud Link or a Synergis™ Master Controller equipped with an RS-485 board.

Streamvault™ appliances are not equipped with RS-485 ports, and are therefore not compatible with direct OSDP readers.

Wiring instructions for STid readers

To enable the extended features of the RS-485 bus, physically place 1.5k Ohm resistors (R1 and R2) on the GND and Vcc connectors of the reader. These 1.5k Ohm resistors do not come with the STid units.