Supported Synergis™ appliance features for SALTO SALLIS integration with Synergis™ Softwire 11.0 - Synergis™ Softwire 11.0

Synergis™ Softwire Integration Guide 11.0

series
Synergis™ Softwire 11.0
revised_modified
2020-11-27
category_custom
Guides
Guides > Integration guides
prodname_custom
Synergis > Synergis™ Softwire
vrm_version
11.0

Not all Synergis™ appliance features are supported with the integration of SALTO SALLIS wireless locks.

The SALTO SALLIS wireless lock integration supports the following and features. For a description of these features, see Interface tour of the Synergis™ Appliance Portal.
Synergis™ Appliance Portal and firmware features Supported
Hardware configuration (pre-staging capability)  
Manual enrollment (Add hardware dialog box) Yes
Automatic enrollment (Scan button) Yes
Property configuration Yes
Configuration cloning (Clone button) Yes
I/O diagnostics (live monitoring of inputs, relays, and readers) Partial1
Interface module firmware display Router only
Interface module firmware upgrade (apply recommended firmware) No
Double-badge activation Yes
Access control behavior (Synergis™ unit-wide settings)2  
Lock relay (After door opens or When door closes) No
Interlock setting (Single door unlock or Single door open) No
Do not generate Door open too long events when door is unrestricted Yes
Reader setting (Card or PIN or Card only) No
Maximum PIN length in digits Not applicable
Degraded mode settings Not applicable

1 Inputs without a sensor attached are not monitored on the I/O diagnostic page.

2 The door behavior settings are overwritten by the individual door settings configured in Security Center.