Configuration overview for Assa Abloy IP locks with Synergis™ Softwire 11.1 - Synergis™ Softwire 11.1

Synergis™ Softwire Integration Guide 11.1

Applies to
Synergis™ Softwire 11.1
Last updated
2021-04-06
Content type
Guides > Integration guides
Language
English (United States)
Product
Synergis™ Softwire
Version
11.1

To configure Assa Abloy IP locks to work with a Synergis™ unit, you must first configure the locks with the Lock Configuration Tool (LCT), and then pair the locks to the Synergis™ unit using Synergis™ Appliance Portal.

The following table summarizes the IP lock configuration process.
Phase Description See
1 Make sure your IP lock firmware is up to date and supported by Synergis™ Softwire 11.1.
2 Configure the IP lock using the LCT.
  • Configure the Host address of the IP lock to be the same as the IP address of the Synergis™ unit.
  • Configure the communication port of the IP lock that the Synergis™ unit will use as a listening port when discovering the locks (Default=2571).
  • If encryption is required, set the AES key in the lock profile. You need this key after you pair the IP lock with the Synergis™ unit.
  • Network & Lock Configuration Tool User Manual that came with your lock.
3 Establish communication between the Synergis™ unit and its connected IP locks in Synergis™ Appliance Portal.

Watch this video to learn more. Click the Captions icon (CC) to turn on video captions in one of the available languages.