Reader connections on the Axis controller - Synergis™ Softwire 11.1

Synergis™ Softwire Integration Guide 11.1

Applies to
Synergis™ Softwire 11.1
Last updated
2021-04-06
Content type
Guides > Integration guides
Language
English (United States)
Product
Synergis™ Softwire
Version
11.1

Each Axis controller supports up to two readers, called Reader 1 and Reader 2 in Security Center Config Tool. The readers can use either Wiegand (default) or OSDP protocol. For OSDP, the reader must be wired to the first set of reader data A-/B+.

The following chart shows which set of connectors correspond to which reader on the Axis controller.
NOTE: This pin chart only shows up if the Axis controller is disconnected to the Synergis™ unit.