Not all Synergis™ appliance features are supported with the integration of Assa Abloy IP locks.
The Assa Abloy IP lock integration supports the following Synergis™ Appliance Portal and Synergis™ Softwire features. For a description of these features, see Interface tour of the Synergis™ Appliance Portal.
|Synergis™ Appliance Portal and firmware features||Supported|
|Hardware configuration (pre-staging capability)|
|Manual enrollment (Add hardware dialog box)||See note1|
|Automatic enrollment (Scan button)||Yes|
|Configuration cloning (Clone button)||No|
|I/O diagnostics (live monitoring of inputs, relays, and readers)||No|
|Interface module firmware display||Yes|
|Interface module firmware upgrade (apply recommended firmware)||Yes|
|Access control behavior (Synergis™ unit-wide settings)3|
|Lock relay (After door opens or When door closes)||Yes4|
|Interlock setting (Single door unlock or Single door open)||No|
|Do not generate Door open too long events when door is unrestricted||Yes|
|Reader setting (Card or PIN or Card only)||Yes|
|Maximum PIN length in digits||65|
|Degraded mode settings||Not applicable|
1 You need to pair the IP lock with the Synergis™ unit.
2 See Enabling passage mode on Assa Abloy IP locks.
3 The door behavior settings are overwritten by the individual door settings configured in Security Center.
4 Works, but the “Lock relay delay” is not taken into account.