Not all Synergis™ appliance features are supported with the integration of SALTO SALLIS wireless locks.
The SALTO SALLIS wireless lock integration supports the following Synergis™ Appliance Portal and Synergis™ Softwire features. For a description of these features, see Interface tour of the Synergis™ Appliance Portal.
|Synergis™ Appliance Portal and firmware features||Supported|
|Hardware configuration (pre-staging capability)|
|Manual enrollment (Add hardware dialog box)||Yes|
|Automatic enrollment (Scan button)||Yes|
|Configuration cloning (Clone button)||Yes|
|I/O diagnostics (live monitoring of inputs, relays, and readers)||Partial1|
|Interface module firmware display||Router only|
|Interface module firmware upgrade (apply recommended firmware)||No|
|Access control behavior (Synergis™ unit-wide settings)2|
|Lock relay (After door opens or When door closes)||No|
|Interlock setting (Single door unlock or Single door open)||No|
|Do not generate Door open too long events when door is unrestricted||Yes|
|Reader setting (Card or PIN or Card only)||No3|
|Maximum PIN length in digits||Not applicable|
|Degraded mode settings||Not applicable|
1 Inputs without a sensor attached are not monitored on the I/O diagnostic page.
2 The door behavior settings are overwritten by the individual door settings configured in Security Center.
3 Card and PIN is not supported.