Adding MR51e panels to a Mercury controller - Synergis™ Softwire 11.2

Synergis™ Softwire Integration Guide 11.2

Applies to
Synergis™ Softwire 11.2
Last updated
Content type
Guides > Integration guides
Synergis™ Softwire
Integration guides

MR51e is a single door PoE panel that must be controlled through a Mercury controller. For the MR51e panel to communicate with the controller, you must set the MR51e panel to use either the Public DHCP (recommended) or the Static IP addressing mode.

Before you begin

Make sure of the following:

What you should know

For Mercury integration through Synergis™ Softwire, you can use the MR51e panel with only two addressing modes: the Public DHCP, and Static IP.
NOTE: Reader port 1 on the MR51e panel can support up to two OSDP readers.


  1. Do one of the following:
  2. In Config Tool, open the Access control task, and click Roles and units.
  3. Select the Synergis™ unit (), and add the MR51e panels.
    For more information, see the steps for adding downstream panels in Enrolling Mercury controllers on the Synergis™ unit.