Enrolling Aperio-enabled locks connected to an AH40 IP hub - Synergis™ Softwire 11.2

Synergis™ Softwire Integration Guide 11.2

Applies to
Synergis™ Softwire 11.2
Last updated
2021-12-17
Content type
Language
English
Version
11.2

For the Synergis™ unit to communicate with Aperio-enabled locks, you must enroll them in the Synergis™ Appliance Portal.

Procedure

  1. Log on to the Synergis™ unit.
  2. Click Configuration > Hardware.
  3. At the top of the Hardware column, click Add ().
  4. In the Add hardware dialog box, select Aperio IP as the Hardware type, and enter the port number of the hub in the Port field. The default port is 9999.
  5. Click Save.
  6. Click Edit () on the Aperio IP interface.
    The configuration dialog box of the channel opens.
  7. In the configuration dialog box, select the Enroll check box for the hub you want to enroll.
    NOTE: If you have configured more than one AH40 hub on the same port, all connected hubs and their MAC addresses are listed.
  8. Click Save.
    The locks connected to the enrolled AH40 hub are listed in the hardware tree and turn green. This can take up to two minutes.