The following software issues are resolved in Synergis™ Softwire 11.2.2.
Interface module | Issue | Description |
---|---|---|
All | 772705 | I/O zones are not shown in the correct state if the interfaces in use are created after the Peer-to-peer option has been enabled. |
Allegion Schlage | 2428574 | Schlage locks with IPB (inside push button): When monitoring locks in Security Center, there is no indication of whether Privacy mode is on or off. |
Assa Abloy IP | 2973078 | SARGENT locks: When the ManageUser command returns the NotImplemented message, cardholders are denied access with the Access denied: Out of Schedule event. |
AutoVu™ | 2693583 | SharpV: In Security Center, the License plate exact match is always true on known plate reads, even if the match is partial. |
Mercury | 2973624 | License plate, Card and PIN, and Card or PIN credentials assigned to the same cardholder or access rules might cause cards and PINs to not be synchronized correctly to Mercury controllers. |
RIO | 2698482 | Outputs assigned to a door entity generate two state change messages a few milliseconds apart for same transition. |
Synergis™ IX | 2762182 | Input state changes are not updated on the I/O diagnostics page of the Synergis™ appliance portal for Synergis™ IX controllers. |
Synergis™ IX | 2100379 | Access denied: Interlock events are not listed in Security Center. |
Synergis™ IX | 1901465 | Activating Trigger pre-alarm events and setting a Pre-alarm delay time in Security Center correctly synchronizes the pre-alarm timer to the panel, but the setting does not get enabled in the web portal, and the check box to enable the pre-alarm in the portal does not work. |