Using Traka Web administration software, prepare the Traka system for integration with Security Center.
Procedure
-
Read the Traka quick start guide and installation guide that applies to your
hardware.
-
Make sure that all Traka cabinets in your system are configured and working as
expected.
-
Get a license for the integration from
ASSA ABLOY.
-
Make
sure that compatible
versions of the required Traka software and services are
installed on the Traka server, running, and configured for integration with
Security Center.
- Business Engine is configured and
Online.
- Comms Engine is configured and
Online.
- Traka Integration Engine Suite is running.
- (Optional) Set up real-time event reporting:
- Real-Time Event Service (RTUS) is
configured and running.
- Real-time events are enabled at each cabinet.
-
On all routers, switches, and network devices, unblock the TCP ports (inbound
and outbound) that are used to communicate with the plugin. The default
ports are:
- TCP 10700 for the Traka Integration Engine
- TCP 10800 for events
-
If Security Center and the Traka
Integration Engine are in different networks or subnets, configure the routers
and firewalls to allow communication; including: enable the routing protocol on
each network's routers, and configure network address translation.
-
Confirm that the Traka system server can communicate with the
Security Center server where the
plugin will be installed, using the Ping command, Telnet, etc.
-
Make sure that the Traka cabinets and Traka Web server are set to the same
time zone as the Security Center
Directory server.
After you finish
If the
Traka Asset Management plugin is not yet deployed or configured, do the following: