If access control cards are being used to access a deister proxSafe locker, you must indicate which card formats are valid.
What you should know
- Multiple different card formats can be used to access assets from a deister proxSafe locker.
- When a cardholder is given access to assets in a cabinet, only one of the cardholder's card credentials will be synchronized to the cabinet.
- The card credential synchronized to a cabinet is based on the priority of a given card format in the card format synchronization settings.
- Card raw credential values are pushed to the deister Commander system whole. The use of fractional data in the deister system to extract card numbers from card reads is unsupported.
Procedure
-
In the Card format synchronization section, select card
types from the Security Center card formats list, and click
to add the to the
Card formats used by deister proxSafe locker
list.
The Security Center card formats list shows the card formats supported by Security Center. For more information on how to add card formats, see the Credentials chapter in the Security Center Administrator Guide.
-
Select a card format from the Card formats used by deister proxSafe
locker list and click
to move it to
the top of the list to establish its priority.
NOTE: If a cardholder has multiple cards that are compatible with the locker, the card with the format that appears highest in the Card formats used by deister proxSafe locker list will be the card that unlocks the proxSafe locker.
Example
- 26-bit Wiegand
- 48-bit Corporate 1000
- 37-bit H10304
If cardholder A has only a 48-bit Corporate 1000 card in Security Center, this 48-bit Corporate 1000 card will be sent to the cabinet.
If cardholder B has both a 37-bit H10304 and a 26-bit Wiegand card in Security Center, the 26-bit Wiegand card will be sent to the cabinet, since it has higher priority in the list.