Before adding Honeywell NVE-1008 and ENC-8M2 encoders to Security Center, additional configuration is required on the unit's web page.
- When adding the NVE-1008 unit to Security
Center, use the IP address of the
On the unit's web page, change the RTP payload type from 104 to another number. This will enable the second stream.
- In Config Tool, set the IP address to the multicast
address on the unit, and set the UDP port to
Configure the encoders to match the camera setting on the unit’s web page. For example, if the camera is set to NTSC, you must configure the encoders to NTSC.
On the unit's web page, set the GOP mode to I or IP and the Frame rate reduction to None.