Not all Security Center access control features are supported with the integration of Aperio-enabled locks from Assa Abloy.
- Feature is supported by this integration.
- Part of the feature is not supported.
- Feature is not supported by this integration.
- Feature is supported only when the interface module is connected to the Synergis™ unit.
- Not applicable
- Feature does not apply to this integration.
|Feature group||Security Center feature||Supported|
|Door behavior settings (overrides the Synergis™ unit-wide settings)||Maintenance mode (keep door unlocked and ignore all access events)||Yes|
|Standard grant time||Yes|
|Extended grant time||Yes|
|Entry time (Standard/Extended)||No|
|Door relock - options||No|
|When door is unlocked by schedule - options||Yes|
|Door held - options||Limited1|
|Door forced open - options||Limited1|
|Request to exit (REX) options|
|Unlock on REX (On/Off)||No3|
|Time to ignore REX after granting access (in seconds)||Yes|
|Ignore REX events while door is open (On/Off)||Yes|
|Time to ignore REX after door closes (in seconds)||Yes|
|Visitor escort and two-person rule|
|Maximum delay between card presentation (in seconds)||Yes|
|Enforce two-person rule (On/Off) on Door side||Yes|
|Manual actions on doors in Security Desk4||Manually unlock doors||v3 locks only|
|Reader shunting (activate/deactivate reader)||Yes|
|Override unlock schedules||Yes2|
|Live event monitoring in Security Desk||Module running state (Online, Offline)||Yes|
|AC fail||Not applicable|
|Battery fail (Low battery)||Yes|
|Door forced open||Yes|
|Door held open for too long||Yes|
|Deadbolt (Secured, Released)||Yes|
|Area restrictions (for secured areas)||Minimum security clearance (part of threat level management)||Yes|
|Visitor escort rule (On/Off)||Yes|
|Hard (log and deny access on Antipassback violation)||Limited6|
|Presence timeout (forget area presence after a certain delay)||Yes|
|Strict (antipassback checked on both area entrance and exit)||Yes|
|Enforce on door unlock schedule||Yes|
|Enforce on access rules||Yes|
|Elevator control||Elevators||Not applicable|
|Zone management||I/O zone||No|
1 The Reader buzzer behavior options are not supported.
2 Update depends on Polling interval (v3 locks) or Status report interval (other than v3 locks).
3 The option Automatically grant REX must always be set to OFF in Config Tool.
4 The Synergis™ unit must be connected to the Access Manager.
5 Not all Aperio-enabled locks support the key override sensor. Confirm with the manufacturer to know the exact sensors that are supported for each model.
6 Not recommended for Card-In/REX-Out doors, because a cardholder's presence in the area cannot be verified