Supported SALTO SALLIS features in Synergis™ Softwire 10.11 - Synergis™ Softwire 10.11

Synergis™ Softwire Integration Guide 10.11

series
Synergis™ Softwire 10.11
revised_modified
2020-06-26

Interface modules come in all shapes and sizes and offer a wide range of features. Synergis™ Softwire supports most of the common features found on the market.

Synergis™ Softwire 10.11 supports the following SALTO SALLIS features.
The following is the legend for some common values found in the Supported column:
Yes
Feature is offered by the interface module and is supported by Synergis™ Softwire.
No
Feature is offered by the interface module but is not supported by Synergis™ Softwire.
Not applicable
Feature is not offered by the interface module.
Features Supported
General characteristics  
Category of interface module Electronic lock
Communication protocol (IP or RS-485)1
Encrypted communication IP and RS-485
Online operation (connected to the Synergis™ unit)  
Standalone mode Not applicable
Supervised mode No
Dependent mode Yes
Offline operation (no connection to the Synergis™ unit)  
Standalone mode No
Degraded mode No
Wireless operation  
Contact the Synergis™ unit on event On read
Scheduled radio contact Every 8 sec.
Battery checks Every 10 min.
Power fail lock settings (Fail Safe/Fail Secure) Not applicable
Scalability  
Maximum number of offline events Not applicable
Maximum number of credentials (for autonomous decision making) Not applicable
Maximum credential length (in bits) 562
Maximum number of interface modules per Synergis™ unit RS-485 channel 163
Recommended maximum number of interface modules per Synergis™ unit 644

1 Protocol between the Synergis™ unit and the SALLIS router.

2 The maximum credential length must be set from the SALLIS application, under Installation Data, IDCode Size.

3 One RS-485 router per channel, and up to 16 locks per router.

4 Either four RS-485 routers with 16 locks each, or one PoE router with 64 locks.