Supported maximum PIN length for Assa Abloy IP locks - Synergis™ Softwire 10.11

Synergis™ Softwire Integration Guide 10.11

series
Synergis™ Softwire 10.11
revised_modified
2020-06-26

The supported maximum PIN length as well as the method for entering the PIN depend on the lock model and the selected reader mode.

The supported maximum PIN entry timeout is 255 seconds.
NOTE: Card and PIN only works with the Always schedule.
CAUTION:
When the reader is in Card or PIN mode, the PIN credential works only if the cardholder also has a card credential.

Sx type locks and some Cx type locks

The following applies to all Sx locks and the following Cx locks: SARGENT and Corbin Russwin IN120 and IN220.
Card or PIN
Up to 6 digits are supported. Enter the 1 to 6 digit PIN followed by '*'.
Card and PIN
Present the card, then enter the 1 to 6 digit PIN followed by '*'.

Px type locks and some Cx type locks

The following applies to all Px locks, Sx locks running Hx firmware, and the following Cx locks: SARGENT Passport 1000 P1 and P2, Corbin Russwin Access 700 PIP1 and PWI1, SARGENT and Corbin Russwin IN120 and IN220 locks with a PERSONA serial number. The IN120 and IN220 locks can either be ordered or configured manually. See instructions below.
Card or PIN
Only 6-digit PINs are supported. Enter '#' followed by the 6-digit PIN.
Card and PIN
Only 4-digit PINs are supported. Present the card, then enter the 4-digit PIN.