Supported Synergis™ appliance features for Assa Abloy IP lock integration with Synergis™ Softwire 10.11 - Synergis™ Softwire 10.11

Synergis™ Softwire Integration Guide 10.11

series
Synergis™ Softwire 10.11
revised_modified
2020-06-26

Not all Synergis™ appliance features are supported with the integration of Assa Abloy IP locks.

The Assa Abloy IP lock integration supports the following Synergis™ Appliance Portal and Synergis™ Softwire features. For a description of these features, see Interface tour of the Synergis™ Appliance Portal.
Synergis™ Appliance Portal and firmware features Supported
Hardware configuration (pre-staging capability)  
Manual enrollment (Add hardware dialog box) See note1
Automatic enrollment (Scan button) Yes
Property configuration No
Configuration cloning (Clone button) No
I/O diagnostics (live monitoring of inputs, relays, and readers) No
Interface module firmware display Yes
Interface module firmware upgrade (apply recommended firmware) Yes
Double-badge activation Yes2
Access control behavior (Synergis™ unit-wide settings)3  
Lock relay (After door opens or When door closes) Yes4
Interlock setting (Single door unlock or Single door open) No
Do not generate Door open too long events when door is unrestricted Yes
Reader setting (Card or PIN or Card only) Yes
Maximum PIN length in digits 65
Degraded mode settings Not applicable

1 You need to pair the IP lock with the Synergis™ unit.

2 See Enabling passage mode on Assa Abloy IP locks.

3 The door behavior settings are overwritten by the individual door settings configured in Security Center.

4 Works, but the “Lock relay delay” is not taken into account.

5 See Supported maximum PIN length for Assa Abloy IP locks.