Repositioning OPTEX lasers on maps in Security Center - Restricted Security Area Surveillance 3.2

Restricted Security Area Surveillance Plugin Guide 3.2

series
Restricted Security Area Surveillance 3.2
revised_modified
2019-04-02

If you want to reposition an OPTEX laser on a map, you must do so from the plugin role's Tracking system page.

Before you begin

  • Confirm that the laser is configured and functioning properly.
  • You must have a geo-referenced map in Security Center.

What you should know

Although it is possible to move a laser on the map in the Map designer task, if you do so, targets will be detected incorrectly. You must only reposition OPTEX lasers from the Tracking systems page of the plugin role.

Procedure

  1. From the Config Tool home page, open the Area view task.
  2. Select the OPTEX tracking system, then click the Properties tab.
  3. In the Specific configuration section, do the following:
    Latitude and Longitude
    Enter the coordinates of the device. Coordinates are in decimal degrees using the World Geodetic System (WGS84) format. You can use a web site like https://www.latlong.net/ to find the coordinates of a specific civic address.
    With map
    To set the device's position using a map, select With map. In the Map list, choose a geo-referenced map. From the map, zoom in and out as needed using the map controls. Click the map to place the device. After clicking the map, the Latitude and Longitude settings are updated with the coordinates from the map.
    For lasers that have a field of view, set the following:
    Orientation:
    If the device has a field of view, identify the physical orientation of the device using compass points. For example: If the device's field of view point towards true North, set the orientation to 0 degrees. You can use a compass to find the degrees. Or, select With map, click the green dot and drag it to the device's orientation.
    Detection area
    Specify the detection area of the device, as listed by the manufacturer.
    For example, the RLS2020S has a detection area of 95 degrees. TIP: If you find that the location of a target is consistently incorrect by small amounts, you can change the detection angle to improve the accuracy. From the tests done in our lab, setting an RLS2020S to 90 degrees resulted in the most accuracy.
    Refresh rate
    Specify how often detected targets are updated on the map. The minimum is 1 second (default), and the maximum is 5 seconds. If you have many targets, you might prefer that targets are refreshed on the map less often.
  4. Click Save.
  5. Click Apply.