Access control unit - Synergis™ - Portal tab - Security Center 5.8

Security Center Administrator Guide 5.8

series
Security Center 5.8
revised_modified
2020-08-17

This section lists the settings found in the Synergis™ access control unit Portal tab, in the Access control task. This tab opens a window to the Synergis™ unit's web-based interface (Synergis™ Appliance Portal) which allows you to configure and maintain the unit.

Synergis™ Appliance Portal allows you to perform the following tasks:
  • Change the security password required to log on to the Synergis™ unit.
  • Configure the network settings on the Synergis™ unit so it works on your system.
  • Enroll and configure the interface modules attached to the Synergis™ unit.
    NOTE: Mercury controllers (EP, LP, and M5-IC), and starting in Synergis™ Softwire 10.11 and Security Center 5.9, Honeywell controllers (PW6K1IC and PRO32IC) must be enrolled and configured from Security Center Config Tool on the access control unit's Peripherals page.
  • Configure the access control behavior of the Synergis™ unit, for both online and offline operations.
  • View the activity logs stored on the Synergis™ unit.
  • Test and diagnose the interface module connections to the Synergis™ unit.
  • View and export the Synergis™ unit's status and configuration.
  • Upgrade the Synergis™ unit's firmware (Synergis™ Softwire).
  • Restart the Synergis™ unit's hardware or software.
  • Update security clearance levels assigned to Security Center areas manually on the appliance when the connection to the Access Manager is lost.