Configuring general settings for intrusion detection scenarios - KiwiVision™ 4.1 GA

KiwiVision™ Video Analytics Guide 4.1 GA

series
KiwiVision™ 4.1 GA
revised_modified
2019-07-10

In the general settings of the scenario, you can configure how areas are displayed in the Security Desk Monitoring task, rename the scenario, change the units of measurement, and so on.

What you should know

Depending on which type of scenario you are configuring, some settings might be unavailable or hidden if Advanced mode is disabled. When Advanced mode is enabled, the advanced settings are displayed in bold.

Procedure

  1. From the Config Tool home page, open the Video task.
  2. From the area view, select a camera that you applied an analytics scenario to.
  3. Click the Video analytics tab, and then click the scenario you want to configure.
  4. Click the General tab.
  5. In the General section, configure the following settings:
    Name
    The name of the analytics scenario. By default, the scenario type is used as the name.
    Tip: Give the scenario a meaningful name so that it can be easily identified. The type of scenario can be distinguished by the different icons.
    Units
    Specifies the unit of measurement. Select either Imperial or Metric units of measurement.
    Imperial
    Specifies the Imperial unit type. For example, 3 ft.
    Metric
    Specifies the metric unit type. For example, 1 m.

    When switching between imperial and metric units, the conversion is rounded to two decimal places. For example, 0.2 m is shown as 0.66 ft.

    NOTE: The region that is set on the machine is read to determine the default setting. The Units setting is saved on the machine and applies to all video analytics on this machine.
  6. In the Analysis section, enter or select the following as required:
    Alert cooldown
    The period that must elapse after an alert is triggered, before another alert can be triggered from the same scenario.
    Filters
    Enable or disable the following filters:
    Rain filter
    Small, fast moving objects, such as rain or snow are ignored when analyzing the image.
    Haze filter
    Estimates the haze density in the image based on the image brightness. The image contrast then changes to remove the haze.
  7. (Optional) In the Overlays in Security Desk section, enable or disable the following overlays:
    Detections
    Displays a yellow box around detected movement or change in a block.
    Alerts
    Temporarily displays an orange outline of an area when an alert is triggered from that area, and displays the detection that triggered the alert in a red rectangular outline.
    Areas
    Permanently displays the outlines of areas.
    Area names
    Displays area names.
    Regions
    (Perimeter protection and Custom Intrusion Detector scenarios only) Source regions of areas are outlined in green, and alarm regions are outlined in red.
  8. Click Apply.