Switching Synergis™ units to different Access Managers - Synergis™ Softwire 10.7

Synergis™ Appliance Configuration Guide 10.7

series
Synergis™ Softwire 10.7
revised_modified
2018-03-27

Once an Synergis™ unit is connected to an Access Manager, it only responds to that Access Manager. If you want the unit to respond to another Access Manager, you need to change its Accepted Access Manager connections list to replace the old one or add the new one.

Before you begin

Enable the Access Manager to connect to the Synergis™ unit by adding the Synergis™ extension in Security Center .

Procedure

  1. Log on to the Synergis™ unit.
  2. Click on Configuration > Network.
  3. Under Access Manager settings, enter the IP address of the new Access Manager in the Accepted Access Manager connections field.

  4. Click Add.
  5. Click Save.

After you finish

If the Synergis™ unit and its new Access Manager are on the same network segment, the unit is automatically added to the Access Manager. If the two are on different network segments, then add the Synergis™ unit to the Access Manager manually.