Changing the PIN entry timeout for doors - Synergis™ Softwire 10.7

Synergis™ Appliance Configuration Guide 10.7

series
Synergis™ Softwire 10.7
revised_modified
2018-03-27

When long PINs are being used, you can change the PIN entry timeout to give cardholders more time to enter their PINs.

What you should know

The default timeout is 5 seconds.

Procedure

  1. Connect to Security Center with Config Tool.
  2. In the Area view task, select the door that requires a longer PIN entry timeout.
  3. Click the Hardware tab.
  4. Beside the Card and PIN reader assigned to the door, click Reader settings ().
  5. In the Reader settings dialog box, enable Use card and PIN, if it’s not already enabled.
  6. Set the Access timeout, and then click Save > OK.
  7. If the desired setting is Card or PIN, do the following:
    1. Click Reader settings (), and disable Use card and PIN.
    2. Click Save.
  8. Click Apply.