Cloning interface module settings - Synergis™ Softwire 10.7

Synergis™ Appliance Configuration Guide 10.7

series
Synergis™ Softwire 10.7
revised_modified
2018-03-27

To save time, you can add new interface modules by duplicating the settings of an existing interface module and then make the changes that apply.

Before you begin

If you want to clone your interface modules but you have already created the new ones, then delete them.

Procedure

  1. Log on to the Synergis™ unit.
  2. Click on the Configuration > Hardware.
  3. In the Hardware configuration page, add and configure an interface module or select one from the hardware tree as your model for cloning.
  4. Click .
  5. In the Add hardware dialog box, add all the interface modules you want to add based on the selected model and click Save.
    All you need to specify for each new interface module is the channel it is connected to and the physical address. All other settings will be copied from the model interface module.

After you finish

Modify the settings of the cloned interface modules as required.