DIP switch command codes for Synergis™ Cloud Link - Synergis™ Softwire 10.7

Synergis™ Appliance Configuration Guide 10.7

series
Synergis™ Softwire 10.7
revised_modified
2018-03-27

You can use the DIP switches on the Synergis™ Cloud Link to run hardware commands.

Available DIP switch commands

There are four DIP switches on the Synergis™ Cloud Link labelled 1 to 4. To run a command, set the DIP switches as indicated in the table below and press the EC button for one second. If the code is valid, the status LEDs will flash green for the process of the command, otherwise they flash red for one second. Synergis™ Cloud Link automatically performs a software restart after you have run a command.

S1 S2 S3 S4 Command description
OFF OFF OFF OFF Resets the Synergis™ Appliance Portal logon password to factory default (softwire).
ON OFF OFF OFF Resets all settings to factory default. This command has the following effects:
  • Resets the Synergis™ Appliance Portal logon password to factory default (softwire).
  • Resets the network addressing mode to DHCP.
  • Resets the discovery port to 2000.
  • Deletes all hardware (connected interface modules) configurations.
  • Deletes all cardholder (credentials and access rules) configurations.
  • Resets all unit-wide settings.
  • Clears all logging options
NOTE: The unit firmware is not affected by this command.
IMPORTANT: Do not power cycle or power down the Synergis™ Cloud Link unit while the status LEDs are flashing green.