Enrolling Synergis™ units in Security Center - Synergis™ Softwire 10.7

Synergis™ Appliance Configuration Guide 10.7

series
Synergis™ Softwire 10.7
revised_modified
2018-03-27

To enroll a Synergis™ unit in Security Center, assign the unit to an Access Manager. The Access Manager must be able to reach the Synergis™ unit on the network, and the Synergis™ unit must be configured to respond to the Access Manager commands.

Procedure

  1. Enable the Access Manager to connect to the Synergis™ unit by adding the Synergis™ extension in Security Center .
    After a few seconds, all new Synergis™ units found on the same network segment as the Access Manager (that have never been enrolled before) will automatically be added to the Access Manager through automatic discovery.
  2. If the Synergis™ unit was previously added to another Access Manager, then you must switch the Synergis™ unit to the Access Manager you want.
  3. If the Synergis™ unit is not on the same network segment as the Access Manager, then you must add the Synergis™ unit to the Access Manager manually.

Results

The Synergis™ unit is connected to its designated Access Manager, and from now on will only respond to commands issued from that Access Manager.

After you finish

Associate the peripherals (readers, inputs, outputs, and so on) controlled by this unit to doors and zones defined in your system. For more information about deploying Synergis™, see Deploying your access control system.