SharpOS 13.1 Sharp Portal - Position and orientation page - SharpZ3 | SharpOS 13.1

SharpZ3 Administrator Guide 13.1

series
SharpZ3 | SharpOS 13.1
revised_modified
2020-07-14

This section lists the settings found in the Position and orientation page of the Sharp Portal. Use the Position and orientation page to define SharpZ3 camera positions on the patrol vehicle roof.

To navigate to the Position and orientation page, click Configuration > Cameras > Position and orientation.

The following information is displayed:

Enable
When enabled, the system estimates the GNSS position of the license plate of the target vehicle.

Position

Left/right
Define how far the camera is installed to the left (0 to -400 cm) or to the right (0 to 400 cm) of the GNSS antenna.
Rear/front
Define how far the camera is installed to the rear (0 to -1000 cm) or to the front (0 to 1000 cm) of the GNSS antenna.
Below/above
Define how far the camera is installed below (0 to -400 cm) or above (0 to 400 cm) the GNSS antenna.

Orientation

Pan
Define how far the camera is panned to the left (-90°) or to the right (90°) from a straight forward view (0°).
Tilt
Define how far the camera is tilted to the up (45°) or down (-45°) from a level installation (0°).
Roll
Define how far the camera is rolled counter-clockwise (-45°) or clockwise (45°) from a level installation (0°).