Adding your IB-System IP server as a tracking system to Security Center - Restricted Security Area Surveillance 4.2

RSA Surveillance Integration Guide for CIAS Perimeter Protection Systems

Applies to
Restricted Security Area Surveillance 4.2
Last updated
Content type
Guides > Plugin and extension guides
Restricted Security Area Surveillance

Before you can monitor the restricted areas secured by your CIAS perimeter protection system in Security Center, you must add each CIAS IB-System IP server as a tracking system in Config Tool.

Before you begin


  1. From the Config Tool homepage, open the Area view task.
  2. Click Add an entity (), and then select Tracking system.
    The Add tracking system wizard opens.
  3. On the Tracking system information page, enter the following information:
    Select CIAS.
    Enter a unique name for this tracking system.
  4. On the Communication page, enter the following information:
    IP address
    The IP address configured in the IB-System IP server.
    The TCP/IP port that the plugin and the tracking system uses to communicate.
    NOTE: By default, CIAS uses port 10001.
  5. Click Refresh connection status () to connect.
  6. When the connection status turns Online (), click Next page ().
  7. On the RSA configuration page, enter the following information:
    Trigger a target at the middle of a segment
    Turn on this setting to activate the automatic creation of a target on the linked segment. The target is placed at the center of the segment on the map.
    Turn on the custom events that you want to monitor for this tracking system.
    NOTE: You can modify this later on the Properties page of the tracking system.
    Fence configuration
    Choose the color for the perimeter when its state changes. The available options vary by system.
    Change color on intrusion
    Turn on this option if you want the perimeter to change color when an intrusion is detected, and then choose the color for the perimeter.
  8. Click Finish.
    The CIAS IB-System IP server and its devices are listed in the Area view entity tree.

After you finish

Create RSA zones.