Logging on to a Streamvault appliance - SV Control Panel | Streamvault

Streamvault™ Appliance User Guide
Applies to
SV Control Panel | Streamvault
Last updated
2023-11-03
Content type
Guides > User guides
Language
English
Product
Streamvault

The first time you start your Streamvault™ appliance, you are prompted to change the default Admin password. You should also change the default Operator password. You can then log on as either an Operator or Admin user.

Before you begin

Learn which access rights the Operator and Admin accounts have.

What you should know

You must be logged on as an Admin user to configure your appliance in the SV Control Panel.
IMPORTANT: Passwords must meet the following requirements:
  • Minimum of 10 characters
  • At least three characters from the following four categories:
    • Uppercase letters
    • Lowercase letters
    • Base 10 digits (0-9)
    • Non-alphanumeric characters (such as $, %, !)

Procedure

  1. Power on the appliance.
  2. Log on using the Admin username and default password that are printed on the appliance.
  3. Enter a new Admin password.
    You are logged on as an Admin user.
    NOTE: Some models have only the Admin account by default.
  4. Log off, and then log on using the Operator username and default password that are printed on the appliance.
  5. Enter a new Operator password.
    You are logged in as an Operator user.
  6. Continue the Operator session, or log out and log back in as an Admin user.

After you finish

Launch the initial setup of your appliance.