Creating a channel to configure OSDP readers in Cloud Link Roadrunner™ 2.0 - Cloud Link Roadrunner™ 2.0

OSDP readers must have their RS-485 bit rate and address configured before they can be used. You can configure your readers directly from the Cloud Link Roadrunner™ Portal by creating an OSDP channel with Programming mode enabled.

1. Log on to the Cloud Link Roadrunner™ unit.
2. Click Configuration > Hardware.
3. At the top of the Hardware column, click Add ().
4. In the Add hardware dialog box, select OSDP as the Hardware type.
5. Select a Channel.
6. Under Interface module type, click Add.
   
7. Click Save.
   The channel and reader are created.
8. From the hardware tree, select the OSDP channel you created and click Edit ().
9. From the Bit rate list, select the bit rate you want to configure for your reader, and then select the Programming mode check box.
   If you have a configuration card, you can use it instead of Programming mode. See the documentation that came with your card.

   
10. Click Save.