The Cloud Link Roadrunner™ Portal is the web-based administration tool used to configure and administer the Cloud Link Roadrunner™ appliance and upgrade its firmware.
You can perform the following tasks through the portal:
- Change the password required to connect to the Cloud Link Roadrunner™ appliance.
- Configure the network settings on the Cloud Link Roadrunner™ appliance so it works on your system.
- Enroll and configure the interface modules connected to the Cloud Link Roadrunner™ appliance.
- Configure the access control behavior of the appliance for both online and offline operations.
- Test and diagnose the interface readers, I/O, and module connections of the Cloud Link Roadrunner™ appliance.
- Configure MIFARE DESFire on OSDP.
- Manage X.509 certificates.
- View and export the Cloud Link Roadrunner™ appliance's status and configuration.
- Upgrade the Cloud Link Roadrunner™ appliance's firmware.
- Restart the Cloud Link Roadrunner™ appliance's hardware or software.
Tasks that must be done in Config Tool
You cannot perform the following tasks through the portal. You have to use Security Center Config Tool instead.- Assign devices (input/output contacts, readers) to doors and zones.
- Configure individual door and zone properties.
- Configure I/O linking.
- Configure Card and PIN readers so both the card and the PIN are required to grant access.
For more information about deploying Synergis™, see the following chapters in the
Security Center Administrator
Guide:
- For configuring doors and Card and PIN readers, see Areas, doors, and elevators in Config Tool.
- For configuring zones and I/O linking, see Zones and intrusion detection in Config Tool.